Skip to content

Methodology

Forestry numbers depend on how they were measured and which method was used. These are the principles every TimberCalcs calculator follows.

Identify the calculation method

Each calculator names the formula, log rule or method it uses. Different methods — for example Doyle, Scribner and International 1/4-Inch — are never treated as interchangeable.

Prefer authoritative sources

We prefer methods published by forestry agencies, university forestry programs and Cooperative Extension services. Where a method has not yet been verified, the calculator is marked as awaiting verified methodology and shows no result.

State assumptions

Units, measurement conventions (such as DBH, inside-bark diameter or actual vs. nominal lumber size) and other assumptions are listed on each page.

Identify estimates

Results are labelled as estimates or theoretical values where appropriate.

Regional and species limitations

Results can vary by region, species, defect, grade and local practice. We note these limits rather than hide them.

Testing

Implemented calculations are tested against reference examples, including edge cases such as decimals, zero, negative and very large inputs.

Not an appraisal or survey

TimberCalcs results are not professional forestry surveys or timber appraisals. Not every calculator has been professionally reviewed. See the disclaimer and sources.