Skip to content

Forestry, Timber & Sawmill Calculators

TimberCalcs

Free calculators for measuring trees, scaling logs, estimating timber, planning stands and working with lumber.

Before you rely on any result here

Every number on this site is an informational estimate. Results can differ from actual log scale, mill recovery, timber appraisal or professional measurement because of species, defects, grading, local practice and the method you choose. TimberCalcs is not a professional survey, appraisal, scaling or grading service, and nothing here is advice for buying, selling or harvesting timber. Before you make a decision that depends on a number — a sale, a purchase, a harvest or a contract — have it verified by a professional forester or licensed timber scaler.

Read the full disclaimer →

Log Volume & Scale Calculator

Inputs

in
ft

Result

Enter values and press Calculate.

About these log rules

Doyle, Scribner Decimal C and International ¼-Inch estimate board feet. Smalian estimates cubic feet. For the board-foot rules, diameter means the small-end diameter inside bark — not DBH, large-end or outside-bark diameter.

  • Doyle: an established board-foot log rule. It can give substantially different estimates from other rules, particularly for smaller logs.
  • Scribner Decimal C: Scribner began as a diagram-based rule; Decimal C is its rounded, table-based form, in 10-board-foot units. TimberCalcs looks values up in the USDA Forest Service table (6–50 in diameters; 4–18 and 20 ft lengths) rather than using a smooth approximation equation. Gross scale before defect deductions.
  • International ¼-Inch: allows for a ¼-inch saw kerf and incorporates an assumed log taper. Results are rounded to the nearest 5 board feet.
  • Compare: the same log gets different estimates because each rule is a different scaling convention. None of them is a measurement of lumber already inside the log, or of actual mill recovery.

Formulas

Doyle BF = (D − 4)² × (L ÷ 16) — 0 BF when D ≤ 4

International ¼-Inch, 4 ft: 0.199D² − 0.642D

International ¼-Inch, 8 ft: 0.398D² − 1.086D − 0.27

International ¼-Inch, 12 ft: 0.597D² − 1.330D − 0.72

International ¼-Inch, 16 ft: 0.796D² − 1.375D − 1.23

D = small-end diameter inside bark (in); L = log length (ft).

International 1/4-Inch results use the USDA Forest Service equations shown in this calculator and are rounded to the nearest 5 board feet. Published tables from other forestry references may differ by 5 board feet for some diameter/length combinations because of coefficient precision and tabulation conventions.

Scribner Decimal C has no formula here: the result is the USDA table value (in tens) × 10. Diameter must be a whole number of inches; it is not rounded for you.

Sources

Measure a stand

Five connected tools for a fixed-area plot inventory, from a tape measurement to stand density.

Browse calculators

All calculators

Why TimberCalcs?

TimberCalcs provides practical forestry, timber and sawmill calculations. Wherever practical, each calculator shows its formula, assumptions and source information so you can see exactly how a number was produced.

Methodology

Forestry calculations can differ by region, species, measurement convention, log rule, scaling method and units. We expose those differences instead of treating different methods as interchangeable.

Our methodologySources